1. 手动调节模块输出电压：根据用户需要在脱离监控的情况下，通过调节
模块前面板上的电压调节电位器，调节模块到指定输出电压值。
Manually modulating module’s output voltage: customer can give any value of output voltage according to his need through modulating the voltage adjustor on the front panel when the module is off the monitoring.
2. 监控系统调节模块输出电压：根据用户需要，通过调节模块控制口的控
制电压，能够调节模块到指定输出电压值。
Manually modulating module’s output voltage: customer can give any value
of output voltage according to his need through modulating control voltage of module control port.
七、注意事项 Notes
1. 模块的输入、输出、均流控制和模块控制端口接触一定要良好，并且使有锁紧功能的端子锁紧。
The contact among ports of module’s input, output, current-dividing control and module control must in good shape, and must be locked by the lock terminal.
2. 多机并联使用时，输出端子汇流线越短越好，不可用长线汇流。建议使用汇流排。
The junction wire should be as short as possible, when many machines run in
parallel connection. Junction board is preferred.
3. 多机并联组成系统时，所有模块输出负极端必须直接相连，彼此之间不许安装加有开关、二极管等元件。
When more than one machines are connected in parallel to set up a system, all the modules’ cathodes must be connected directly without any element such as switch or diode between them.
4. 模块运行时，不要用异物挡住模块的自然冷却风道。
Don’t cover the natural cooling duct when module running
八、简单故障处理Trouble Shooting
1. 模块输出电压不正确：通过调节模块前面板上的电压调节电位器，调节