:for i from=2 to=4 do={interface vlan add name=(\
:for i from=2 to=4 do= {/interface pppoe-client add name=(\
:for i from=2 to=4 do={/ip firewall mangle add chain=input action=mark-connection new-connection=(\:for i from=2 to=4 do={/ip firewall mangle add chain=output connection-mark=(\
:for i from=2 to=4 do= {/ip firewall mangle add chain=prerouting src-address-list=lan-add action=mark-connection new-connection-mark=(\per-connection-classifier=(\
:for i from=2 to=4 do={ /ip firewall mangle add chain=prerouting src-address-list=lan-add action=mark-routing new-routing-mark=(\:for i from=2 to=4 do= {ip route add dst-address=0.0.0.0/0 gateway=(\ip route add dst-address=0.0.0.0/0 gateway=pppoe-out4 ip firewall nat add chain=srcnat action=masquerade
1、首先划分VLAN（我们这里是从2开始排序的），脚本如下：
:for i from=2 to=4 do={interface vlan add name=(\
2、然后添加PPPOE拨号（先添加拨号再手动输入 每个AD的帐号和密码，40条AD设置还是要花点时间了），脚本如下
:for i from=2 to=4 do= {/interface pppoe-client add name=(\
3、我们这里采用PCC的负载均衡，在ip firewall mangle里添加相应的PCC规则，通过一些脚本添加PCC的规则，注意：如果PPPoE客户端拨号没
有成功，那么添加的规则则为红色的，拨号成功后自动正常
:for i from=2 to=4 do={/ip firewall mangle add chain=input action=mark-connection new-connection=(\
4.然后标记路由让从哪个接口进来的数据就从哪个接口出去：
:for i from=2 to=4 do={/ip firewall mangle add chain=output connection-mark=(\
5．然后将所有内网出来的数据通过pcc的both-addresses分成40分并标记连接和路由：
:for i from=2 to=4 do= {/ip firewall mangle add chain=prerouting src-address-list=lan-add action=mark-connection new-connection-mark=(\per-connection-classifier=(\
:for i from=2 to=4 do={ /ip firewall mangle add chain=prerouting src-address-list=lan-add action=mark-routing new-routing-mark=(\
6.为每个路由标记添加路由并添加pppoe-out41为默认路由：
:for i from=2 to=4 do= {ip route add dst-address=0.0.0.0/0 gateway=(\ip route add dst-address=0.0.0.0/0 gateway=pppoe-out4
7．最后做NAT伪装，一般最好是对每个出口进行伪装： ip firewall nat add chain=srcnat action=masquerade