同步
? 如何验证同步 ? get sync
? 验证设备同步状态 ? st sync
? 验证处理的同步 ? get . clock
总结：刘彬 page 11 of 17
? 8种同步状态
序号 0 状态 UNKNOWN_MODE STARTUP_MODE The system clock is starting up. The system clock signal on the Timing Unit is locked: a the clock accuracy is 50 ppb or better. 系统时钟启动。 在计时装置的系统时钟信号锁定：同步50ppb或更好。 原文说明 翻译 1 2 LOCKED_MODE HOLD_OVER_MODE FREE_RUsynchronization reference is used to generate the system clock, 参考是用来产生系统时钟，时钟精度为The system clock signal on the Timing Unit has holdover quality: 在定时单元的系统时钟信号保持质量：no synchronization reference is used to generate the system 不同步的参考是用来产生系统时钟，时clock, the clock accuracy is 50 ppb or better. 钟精度为50 ppb或更好。 3 The system clock signal on the Timing Unit is free-running: no 在计时装置的系统时钟信号是自由运行synchronization reference is used to generate the system clock, 的：没有同步参考是用来产生系统时钟，the clock accuracy is 4.6 ppm or better. 时钟精度为4.6 ppm或更好。 4 NNING_MODE FAILED_MODE LOSS_OF6 _TRACKING_MODE 7 NOT_APPLICABLE The system clock signal on the Timing Unit is failed: there is 在计时装置的系统时钟信号是失败的：fault in generating the system clock, no guarantee of clock 在产生系统时钟故障，不能保证时钟精accuracy level. 度。 5 The frequency of the system clock is at its upper or lower limit. 系统时钟的频率的上限或下限。 The system clock signal on Timing Unit is not applicable: the 系统时钟信号的定时单元不适用：TUBTUB or the CBU is not present. 或CBU不存在。
告警
? 如何检查小区告警 ? alt
总结：刘彬 page 12 of 17
? 如何检查每个报警的更多细节 ? ala
? 如何检查小区告警日志 ? lga -2d (-2d表示2天) ? lga
总结：刘彬 page 13 of 17
eNB功率设置，PCI，和杂项 ? 如何检查基站功率设置 ? get . power
总结：刘彬 page 14 of 17
这是3个步长的eNB功率参数
? 详细的eNB功率设置 Power per Radio Unit [W]:
H/W Capability:
RU硬件功率容量限制。 License Power Available: 功率的容量来源与功率license partOfRadioPower= 100 {0..100} LTE分管分享Ru用功率规定部分
confOutputPower= 20 {20, 40, 60, 80, 120} [W] 用以限制在部门功率
? 如何更改功率设置
? set SectorEquipmentFunction=S1 confoutputpower 40
总结：刘彬 page 15 of 17