network administrator is configuring several switches for a network. The switches have similar configurations and only minor diffin HyperTerminal?
administrator wants to save all commands that are issued on the first switch to a text file for editing. Which transfer option shoul
2A routing issue has occurred in your internetwork. Which of the following type of devices should be examined to isolate this
access point
host hub router switch
3
Refer to the exhibit. While configuring a network, a technician wired each end of a Category 5e cable as shown. Which twoare true about this setup? (Choose two.)
The cable is suitable for connecting a switch to a router Ethernet port.
The cable is suitable for connecting dissimilar types of devices.
The cable is unusable and must be rewired.
The cable is terminated in a way that the transmit pin is wired to the receive pin.
The cable simulates a point-to-point WAN link.
4W hich three IPv4 addresses represent subnet broadcast addresses? (Choose three.)
192.168.4.63 /26
192.168.4.129 /26
192.168.4.191 /26
192.168.4.51 /27
192.168.4.95 /27
192.168.4.221 /27
5
Which service is used when the nslookup command is issued on a computer?
FTP DNS DHCP Telnet
6
How will a packet that is sent from host A to host B be handled by the devices on the network?
R1 will drop the packet because R1 does not have a specific route in its routing table to the 10.1.1.0/24 network.
Refer to the exhibit. Host A is configured with the correct IP address for the default gateway of the router R1 FastEthernet0
R1 will forward the packet to its default gateway, the next hop router R2. R2 will forward the packet to the directly conn 10.1.1.0/24.
R1 will forward the packet to its default gateway, the next hop router R2. R2 will drop the packet because it does not h route to network 10.1.1.0/24.
R1 will forward the packet to its default gateway, the next hop router R2. R2 will drop the packet because it does not h that is learned by a routing protocol to network 10.1.1.0/24.
7
Which prompt represents the appropriate mode used for the copy running-config startup-config command ?
Switch-6J>
Switch-6J#
Switch-6J(config)#
Switch-6J(config-if)#
Switch-6J(config-line)#
8
should be pinged from this host to confirm that the router interface is operational?
127.0.0.1
192.168.64.196
192.168.254.1
192.168.254.9
192.168.254.254
Refer to the exhibit. A technician is working on a network problem that requires verification of the router LAN interface. Wh
9
What is the effect of using the Router# copy running-config startup-config command on a router?
The contents of ROM will change.
The contents of RAM will change.
The contents of NVRAM will change.
The contents of flash will change.