Windows 98 is now starting your MS-DOS-based program Windows 98正在启动基于MS-DOS的步伐 Windows 98 is now restarting... Windows 98正在重新启动
Press Esc now to cancel MS-DOS mode and restart Windows 98... 按Esc退出MS-DOS 模式，重新启动Windows 98… There is an unrecognized command in your CONFIG.SYS file 在你的CONFIG.SYS文件中有不可辨认的命令
The following command in your CONFIG.SYS file is incorrect: 在你的CONFIG.SYS有下列错误命令 The sector size specified in this file is too large: 该文件中指定的扇区太大
The following file is missing or corrupted: WIN.COM COMMAND.COM 下列文件丢掉或被粉碎：WIN.COM以及COMMAND.COM There is an invalid country code or code page in your CONFIG.SYS file 在你的CONFIG.SYS里有1个无效的国家代码
There is an error in the COUNTRY command in your CONFIG.SYS file 在你的CONFIG.SYS里有1个错误的设置国家命令 There is not enough memory for the COUNTRY.SYS file 没有足够的内存来加载COUNTRY.SYS文件
Remove some drivers from your CONFIG.SYS file, and then try again
请从CONFIG.SYS文件中删除部分驱动步伐，然后再试 Remove some drivers, and then
try again
去除一些驱动步伐，然后再试这里的驱动步伐是指在CONFIG.SYS中使用device或devicehigh命令加载的步伐文件
Remove some disk drivers from your CONFIG.SYS file, and then try again
从你的(CONFIG.SYS)移去部分步伐，然后再试
The configuration specified in your CONFIG.SYS file is too large for memory
调解你的CONFIG.SYS文件以获得足够大的内存
You have too many block devices specified in your CONFIG.SYS file
调解你的CONFIG.SYS文件以获得block devices
The STACKS setting(s) in your CONFIG.SYS file are incorrect
在你的CONFIG.SYS中堆栈设置不不错
Default stack settings will be used instead
缺省的堆栈设置将被替代使用
There is an error in your CONFIG.SYS file on line XX
在你的CONFIG.SYS里XX行错误
Warning: Logical drives past Z exist and will be ignored
警告：逻辑驱动器Z已经存在，将被纰漏
Type the name of the Command Interpreter (e.g., C:\\WINDOWS\\COMMAND.COM) Press any key to continue…
请输入命令解释器的文件名(如：C:\\WIN DOWS\\COMMAND.COM)后，按任意键继续
Windows is bypassing your startup files
Minimal network support will be loaded if available
Windows正在跳过你的启动文件如果收集可用，最小收集支持将被加载
Windows is starting the command prompt only
Windows正在启动命令字符模式
Windows will prompt you to confirm each startup command
Windows将提醒你明确承认每1个启动命令
The compression driver cannot be set up correctly
压缩驱动步伐不能被不错加载
Get a version from your vendor that is compatible with this version of Windows
从你的供应商那里获得1个与Windows版本相兼容的版本
Process the system registry
运行系统注册表
Create a startup log file (BOOTLOG.TXT)
创建启动日志BOOTLOG.TXT文件
Process your startup device drivers (CONFIG.SYS)
运行CONFIG.SYS文件中的装备驱动
Process your startup command file (自己主动EXEC.BAT)
运行自己主动EXEC.BAT中的启动命令
Load the Windows graphical user interface
装入WINDOWS图形用户界面(GDI)
Warning: Windows has detected a registry/configuration error. Choose, Command prompt only, and run SCANREG
警告：Windows检测到1个注册表或配置错误选择DOS操作模式，运行SCANREG
Warning: Windows has detected a compressed drive access error. Choose Safe mode command prompt only, to help you identify the problem
警告：Windows检测到1个访问压缩驱动器错误，选择安全模式下的MS-DOS，来帮忙你辨认这个需要别人解答的题目
Warning: Windows did not finish loading on the previous attempt. Choose Safe mode, to start Windows with a minimal set of drivers
警告：Windows在刚才尝试后不能够完成加载，选择安全模式，用最小驱动启动你的电脑
Warning: Windows multi-boot may not function correctly
Check for system files in your root directory with conflicting extensions
警告：Windows不能够不错完成多系统启动，在你的ROOT目次里检查不相符的系统文件
Warning: the system configuration manager failed to run. Some of your real-mode device drivers may not initialize properly
警告：系统办理器运行掉败，一些实模式驱动有可能没有不错初始化
The BUFFERS setting(s) in your CONFIG.SYS file are too large. Default buffer settings will be used instead
在你的CONFIG.SYS里BUFFER设置太大默许的BUFFER缓以及冲突器设置将被使用
A memory allocation error occurred during startup
>Restart your computer and select Interactive Start to identify the problem
在启动过程中内存分配发生错误，请重新启动你的计算机然后选用交互式体式格局启动来确定妨碍原因
Warning: the high memory area (HMA) is not available Additional low memory (below 640K) will be used instead
警告：高端内存不可用，低端内存将被代替使用
There is not enough memory for Windows. Remove some drivers from your CONFIG.SYS file, and then try again
对Windows来讲没有足够的内存，请从CONFIG.SYS文件中移去部分加载的步伐，然后再试着启动你的读入计算机 Your previous MS-DOS files were not found. 旧的MS-DOS文件没有找到，这常见于使用双启动的系统，另1个系统是DOS6
Your previous MS-DOS version is not supported. MS-DOS startup failed
旧的MS-DOS版本不支持MS-DOS启动掉败
Now loading your previous version of MS-DOS, please wait
此刻正在加载旧的MS-DOS版本，请等待
Invalid setting in the MSDOS.SYS file:An internal stack overflow has caused this session to be halted
MSDOS.SYS文件中无效的设置选项系统堆栈溢出，系统挂起
Change the STACKS setting in your CONFIG.SYS file, and then try again
请改变CONFIG.SYS文件中的STACK设置，然后再试
Stack overflow
堆栈溢出
Integer divide by 0
整儿被0除
Not enough space for environment
没有足够的空间
Run-time error
运行错误
Floating-point support not loaded
浮点运算支持没有装入
Null pointer assignment
无效的断点分配
六、COMMAND中的提醒信息