涡流探伤仪操作规程 - 图文(3)

7. Mark assignment Config (Key 1) Open configuration menu By rotary switch Choose option Mark assignment and push; then appears a menu as (4 on fig 01) below picture By rotary switch First, ensure the option Marking output is on; if not the output signals (4 on fig 01) will not be open in any case. To change the status of this option you should select by the rotary switch, push and select on of the menu that presents. Then select Marking Equipment Push and will open a list, select M1..M4 (it means all the output signals are potentially open) select: Mark Assignment CH1 Mark Assignment CH2 Will be open a table as you can see in the picture (left below side of the screen), select each output of the equipment: M1 a M4; a defect slight or sever in each one of the two channels, it is possible assign logical operations as F1&F2. The option no will be used to not assign any signal in the correspondent output.