发动机反推显示丢失排故工卡(6)

A/C REG 机号 B-5488 Item 工序 ＡＤＩＲＳ启动 REV. DATE TITLE 标题 LOSS OF THE THRUST REVERSER INDICIATION 修正日期 ON ENGINE 1 OR 2 2013-10-20 1号或2号发动机反推显示丢失 Job Description 工作单内容 CARD NO 卡号 AMM71-00-58 MECH INSP工作者 检查者 On the center pedestal, on the SWITCHING panel 8VU, make sure that the selector switches are at NORM. 在中央操纵台的“开关”面板8VU上，确保选择开关都在“正常”位。 Do the ADIRS start procedure (Ref. TASK 34-10-00-860-002). 进行ADIRS启动程序 TASK 34-10-00-860-002 ADIRS Start Procedure ADIRS启动程序 Job Set-up Information ：access platform 1.6 m (5 ft. 3 in.) 工作准备：1.6m的平台（5英尺3英寸） A. Aircraft Maintenance Configuration 飞机构型确认 WARNING : MAKE SURE THAT ALL PERSONS ARE AWAY FROM THE SATCOM ANTENNAS (MORE THAN 3 METERS) WHEN YOU DO THIS TEST. THE SATCOM ANTENNAS USE HIGH POWER WHEN THEY TRANSMIT AND CAN CAUSE INJURY TO PERSONS. 警告：做测试时确保所有人员都远离卫星通讯天线（超过3米远）。 卫星通讯天线传送信号时能量很高，会对人员造成伤害。 B. Get Access 进入 (1) Put the access platform in position at the access door 822. 将接近平台放在822号接近门位置。 PAGE 页码 OF 2 A/C REG 机号 B-5488 Item 工序 REV. DATE TITLE 标题 LOSS OF THE THRUST REVERSER INDICIATION 修正日期 ON ENGINE 1 OR 2 2013-10-20 1号或2号发动机反推显示丢失 Job Description 工作单内容 CARD NO 卡号 AMM71-00-58 MECH INSP工作者 检查者 (2) Open the access door 822 打开822号接近门。 (3) On the battery power center 105VU: 在电瓶中心105VU位置： - loosen the two screws and remove the protective cover 松开两个螺钉，取下保护罩。 B. Make sure that this(these) circuit breaker(s) is(are) closed: 确保下面的电路断路器已经关闭： -------------------------------------------------------------------------------- PANEL DESIGNATION面板标识 IDENT. LOCATION位置 -------------------------------------------------------------------------------- 49VU NAV PROBES/ADIRU3/PWR/SWTG 8FP F09 49VU NAV PROBES/ADIRU 1/AND AOA 1/26VAC 5FP1 F07 49VU NAV PROBES/ADIRU1/115VAC 4FP1 F06 105VU ADIRS/ADIRU1/28VDC 6FP1 C02 R **ON A/C 001-200, 205-400, 121VU ADIRS/ADIRU/2PWR/SHED 10FP N10 121VU ADIRS/ADIRU/3PWR/SWTG 9FP N09 121VU ADIRS/ADIRU/2/26VAC AND AOA 5FP2 N08 121VU ADIRS/ADIRU/3/26VAC AND AOA 5FP3 N07 121VU ADIRS/ADIRU/2/115VAC 4FP2 N06 121VU ADIRS/ADIRU/3/115VAC 4FP3 N05 121VU ADIRS/ADIRU/2/28VDC 6FP2 N04 121VU ADIRS/ADIRU/3/28VDC 6FP3 N03 PAGE 页码 OF 2 A/C REG 机号 B-5488 Item 工序 REV. DATE TITLE 标题 LOSS OF THE THRUST REVERSER INDICIATION 修正日期 ON ENGINE 1 OR 2 2013-10-20 1号或2号发动机反推显示丢失 Job Description 工作单内容 CARD NO 卡号 AMM71-00-58 MECH INSP工作者 检查者 -------------------------------------------------------------------------------- PANEL DESIGNATION面板标识 IDENT. LOCATION位置 -------------------------------------------------------------------------------- **ON A/C 201-204, 121VU ADIRS/ADIRU/2PWR/SHED 10FP N11 121VU ADIRS/ADIRU/3PWR/SWTG 9FP N10 121VU ADIRS/ADIRU/2/26VAC AND AOA 5FP2 N09 121VU ADIRS/ADIRU/3/26VAC AND AOA 5FP3 N08 121VU ADIRS/ADIRU/2/115VAC 4FP2 N07 121VU ADIRS/ADIRU/3/115VAC 4FP3 N06 121VU ADIRS/ADIRU/2/28VDC 6FP2 N05 121VU ADIRS/ADIRU/3/28VDC 6FP3 N05 A. ADIRS Start Procedure. ADIRS启动程序 (1) On the overhead panel, on the ADIRS CDU: 在头顶面板上的ADIRS的控制显示组件： (a) Set the three OFF/NAV/ATT selector switches to NAV. 将OFF/NAV/ATT三个选择按钮旋到NAV位。 (b) Make sure that the ON BAT light comes on for 5 seconds and the ALIGN legend of the IR1, IR2 and IR3 annunciators comes on. 确保ON BAT灯亮５秒钟，IR1,IR2,IR3的信号器上ALIGN标识出现。 PAGE 页码 OF 2 A/C REG 机号 B-5488 Item 工序 REV. DATE TITLE 标题 LOSS OF THE THRUST REVERSER INDICIATION 修正日期 ON ENGINE 1 OR 2 2012-12-5 1号或2号发动机反推显示丢失 Job Description 工作单内容 CARD NO 卡号 AMM71-00-58 MECH INSP工作者 检查者 (c) Make sure that the FAULT and OFF legends of the ADR1, ADR2 and ADR3 pushbutton switches are off. 确保ADR1，ADR2，ADR3按键上的的FAULT和OFF标识是熄灭的。 (2) On the CAPT and F/O main instrument panels, on the PFDs : 在机长和副驾驶位的主仪表板上，在PFD上： - make sure that the CAS, ALT and V/S come into view. 确保CAS，ALT和V/S都出现。 - make sure that the attitude data come into view 40 seconds approximetaly after the three selector switches are at NAV. 确保在三个选择键在NAV出现后大约40秒后姿态数据出现。 (3) On the ADIRS CDU, set the SYS DISPLAY selector switch to 1 and the DATA DISPLAY selector switch to PPOS, and make sure that dashes are shown on the CDU display. 在ADIRS的控制显示组件上，将系统显示选择键旋到1，将数据显示选择键旋到PPOS，确保这些破折号在CDU上显示。 A. Close Access 关闭接近门 (1) Install the protective cover on the battery power center 105VU. 在电瓶中心105VU处安装保护罩。 (2) Tighten the two screws. 拧紧两个螺钉。 PAGE 页码 OF 2 A/C REG 机号 B-5488 Item 工序 检查P/N更新 REV. DATE TITLE 标题 LOSS OF THE THRUST REVERSER INDICIATION 修正日期 ON ENGINE 1 OR 2 2012-12-5 1号或2号发动机反推显示丢失 Job Description 工作单内容 CARD NO 卡号 AMM71-00-58 MECH INSP工作者 检查者 (3) Close the access door 822. 关闭822号接近门。 (4) Remove the access platform(s). 移开接近平台。 D. Check the P/N update 检查P/N更新 (1) Do the procedure to get the SYSTEM REPORT/TEST INST:DISPLAY page 做下列程序得到系统REPORT/TEST INST显示页面。 (Ref. TASK 31-32-00-860-008) TASK 31-32-00-860-008 Procedure to Get Access to the SYSTEM REPORT/TEST/INST Page 得到系统REPORT/TEST INST显示页面的程序 NOTE : IGNORE ALL THE ECAM WARNINGS AS LONG AS THE COMPUTER IS IN THE MENU MODE. 提示：当电脑在菜单状态时忽略所有的ECAM警告信息。 Make sure that this(these) circuit breaker(s) is(are) closed: 确保下列断路器都已闭合： ---------------------------------------------------------------------------------PANEL DESIGNATION面板标识IDENT.LOCATIO代码和位置 --------------------------------------------------------------------------------- 49VU AUTO FLT/MCDU/1 11CA1 B01 121VU CFDS/CFDIU/SPLY 2TW J18 121VU CFDS/CFDIU/BACK/UP 8TW J17 121VU AUTO FLT/MCDU/2 11CA2 N20 PAGE 页码 OF 2