thermal_considerations_for_high_brightness_LEDs_5

2021-04-05 11:57

© 2006 Zetex Semiconductors plc Feature article

Reference: ZE0500

Date: 5 October 2006

Thermal considerations for high brightness LEDs Colin Davies, Applications Manager, Zetex Semiconductors

Much attention is being focused on the dimming strategies used for controlling high brightness LEDs in a rapidly increasing number of applications. The nature of these devices demands however that even more attention be paid to thermal control.

While LED manufacturers are pushing back the technological boundaries by dramatically increasing the Lumens per Watt, there is still more electrical power converted to conducted heat than to light output. An overall strategy of thermal management is required to ensure that the power into the LED is controlled as a function of temperature.

The curve in figure 1 shows typical derating characteristics for a 1W LED. As expected, this clearly shows that the LED is driven with constant current up to a point at which the current then needs to be reduced linearly to 0 at 150°C. The point at which this derating occurs and the slope of the decrease is dependent on the mechanical/thermal heat sinking arrangement.

Fig 1

2

The control electronics must therefore be able to cope with a trip point setting and a gain setting. It’s also important to remember that the LED needs to be able to cope in fact with three potential contributors to the heating effect: self heating, ambient temperature and the LED electronic control. If the electronic control is remote from the LED illumination, then this will not be an issue – EMC however may be a concern.

Linear control of the LED

Take a trip back to the textbook and the first and most obvious way of controlling an LED is with a resistor. Although a low cost method, it inevitably results in power loss which negates or diminishes the LED’s key efficiency attribute. Using a variable resistor as the dimming element is also impractical for high brightness LEDs since the power in the resistor will be too large and a dedicated wire wound device would be required. As an illustration, for a single 1W LED taking 350mA from a 12V supply, around 2.5W would be wasted in the dimming resistor at full brightness. And if the resistor is in close proximity to the LED then the extra heating it produces will only add to the problem.

The pass element could of course be a transistor, which would mean the power dissipation resides in the transistor and not the variable resistor. This approach provides more flexibility by enabling logarithmic response, negative (NTC) or positive (PTC) temperature coefficient thermistors to be used for thermal control and brightness definition. A bit of imagination then easily leads to the use of optical feedback for automatic brightness control.

The transistor could be of any type: MOSFET, NPN bipolar or PNP bipolar. Amazingly some engineers of a more digital persuasion still believe that MOSFETs are better for this application because of their low on resistance! It simply has to be understood that linear power dissipation is the same regardless of silicon choice. It’s still wasted power in the form of heat which needs to be managed.

© 2006 Zetex Semiconductors plc


thermal_considerations_for_high_brightness_LEDs_5.doc 将本文的Word文档下载到电脑 下载失败或者文档不完整,请联系客服人员解决!

下一篇:峡江县国税局税源管理科二00八年工作总结

相关阅读
本类排行
× 注册会员免费下载(下载后可以自由复制和排版)

马上注册会员

注:下载文档有可能“只有目录或者内容不全”等情况,请下载之前注意辨别,如果您已付费且无法下载或内容有问题,请联系我们协助你处理。
微信: QQ: