5
Thermistor control with a switching regulator.
Figure 3 shows a typical example of a step down (buck) regulator using simple thermal control. Here advantage is taken of the ADJ pin of Zetex Semiconductor’s ZXLD1350. By overdriving the pin using a PNP transistor as an emitter follower and using the pin’s internal 250k? resistor as a load, the LED current falls in proportion to the thermistor resistance. As the temperature drops, the resistance of the thermistor increases, but as the base voltage increases beyond the ADJ reference voltage, the transistor turns off and the LED receives only its maximum set current, thereby clamping the low temperature response.
Fig. 3 - A step down (buck) regulator using simple thermal control. Matching the thermal de-rating curve for a given LED will depend on many factors as discussed earlier. Good thermal modelling will help get this right first time but it is likely that some experimentation is required to match the trip point
and gain coefficient. Figure 4 shows the results of several tests using the
circuit in Figure 3.
© 2006 Zetex Semiconductors plc