柴油机连杆的有限元分析 英文资料
[2] WANG Wenzhu, CHENG Mianhong,Liu Gang,etc, “Finite
element method coupling analysis for a engine piston assembly” in Machinery Design & Manufacture, pp 186-188 , April 2009
[3] HU Dongqing, “Three Dimensional Finite Element Analysis of
Engine Connecting Rod”in Journal of Anhui Agricultural Science , vol.37, pp.:6458-6460, July 2009
(b)
(c)
Figure 9. The changed stress of the crankshaft flexible-body with the
crankshaft’ angle
(a)VON MISES stress (b) biggest main stress (c)smallest main
stress
Figure 10. The drawing of the VON MISES stress, biggest main stress,
smallest main stress of the crankshaft flexible-body
Now we can draw a conclusion as follow:
(1) In one working cycle of connecting rod, the stress was mainly produced on the joint of connecting rod shell and the bottom end or the top end.
(2) The biggest stress acted on the connecting rod big end. Its simulation value was just 34.0613MPa, early smaller than its limited stress 355MPa, the simulation result showed that the stability of the mechanism was well.
V.
CONCLUSIONS
The connecting rod of the S195 diesel engine was analyzed with the Hyperworks and MSC.Nastran, and the result was very reasonable. So it is important for improvement of the design for engine connecting rod. The simulation analysis was really an economical and efficient method to study.
ACKNOWLEDGMENT
It is a project supported by Beijing Training Program Foundation for the Talents
REFERENCES
[1] Shi Jiankui “Finite Element Modal Analysis of Vehicle Engine
Connecting Rod,” in Equipment Manufactring Technology , pp.22-24, June 2009